Please explain the operation of the "wait to start" light, its
What Controls The Wait To Start Light. The light should always illuminate briefly, when the ignition key is in the on. Try it again, but this time i wait till after light goes out, then i watch to see voltmeter jump in positive direction and she starts.
2.turn the key on and look for an initial reading of 160 amps or more. Check all 8 glow plugs. Web this message reminds you that the diesel engine may take a few minutes to start. Web 1.install the clamp on meter around the two output wires from the glow plug relay. Web the wait to start light was dim and flickering when trying to start it. The light should always illuminate briefly, when the ignition key is in the on. Web the pcm controls the wts light and i would guess that your wiggling the fuses caused this fuse to make contact again. Wait until the light goes off before starting. It was cranking over but would not start so i had it towed home. Web if you suspect a problem with the starting system (control box):
2.turn the key on and look for an initial reading of 160 amps or more. Check all 8 glow plugs. It was cranking over but would not start so i had it towed home. When the ignition switch is. Web if you suspect a problem with the starting system (control box): Web the pcm controls the wts light and i would guess that your wiggling the fuses caused this fuse to make contact again. For most diesels, the light turns off when the glow plugs reach the established. It may be worth picking up a can of. Web illuminate if glow plug heat is necessary as a starting aid. The light should always illuminate briefly, when the ignition key is in the on. I changed the selinoid last night and the light would come on for a couple on secounds and then go off.
